Managing DNAT rules
Managing DNAT rules
The table of DNAT rules is displayed in the firewall template and on the CPE device:
- To display the table of DNAT rules in a firewall template, go to the SD-WAN → Firewall templates menu section, click the firewall template, and in the displayed settings area, select the NAT → DNAT tab.
- To display the table of DNAT rules on a CPE device, go to the SD-WAN → CPE menu section, click the device, and in the displayed settings area, select the Firewall settings → NAT → DNAT tab.
Information about DNAT rules is displayed in the following columns of the table:
- Name is the name of the DNAT rule.
- Incoming contains the criteria according to which the firewall must apply the DNAT rule to traffic packets:
- Redirect to is the destination IP address and port of traffic packets after the DNAT rule is applied.
Did you find this article helpful?
What can we do better?
Thank you for your feedback! You're helping us improve.
Thank you for your feedback! You're helping us improve.