Disabling or enabling an IP set

You can disable or enable an IP set in a firewall template or on a CPE device. When you disable or enable an IP set in a firewall template, the set is automatically disabled or enabled on all CPE devices that are using the template.

To disable or enable an IP set:

1. Disable or enable an IP set in one of the following ways:
   • If you want to enable or disable an IP set in a firewall template, go to the SD-WAN → Firewall templates menu section, click the template and in the displayed settings area, select the IP sets tab.
   • If you want to enable or disable an IP set on a CPE device, go to the SD-WAN → CPE menu section, click the device, and in the displayed settings area, select the Firewall settings → IP sets tab and select the Override check box.

   A table of IP sets is displayed.

2. Click Disable or Enable next to the IP set that you want to disable or enable.

   The IP set is disabled or enabled.

3. In the upper part of the settings area, click Save to save the settings of the firewall template or CPE device.