Step 2. Modifying routing settings

At this step, you can modify the default route settings and static routes.

To modify routing settings:

1. In the Select Action – Routing window, select routing settings that you want to modify.

   

   • The network adapter of the default route
     1. Select Interface and press ENTER.

        This opens the Select gateway device window.

        

     2. Select the network adapter that must be used for the default route and press ENTER.
   • Default gateway address
     1. Select Gateway and press ENTER.

        The Interface gateway configuration window opens.

        

     2. Change the default gateway address and click Оk.
   • Static route
     1. Select Edit static routes and press ENTER.
     2. This opens the Select Action – Routes window.

        

2. If you want to modify a static route, you can take the following actions:
   • Modifying the settings of an existing static route
     1. In the Select Action – Routes window, select a route from the list.

        This opens the Select Action – Edit static routewindow.

        

     2. Select the row of the setting, press ENTER, then in the Edit static route window, use the TAB key to select the relevant setting, edit its value and click Ok.

        

     3. To change the network adapter of the selected route, in the Select Action – Edit static route window, select Route via, then in the Select interface to set route via window, select the network adapter for the static route and press ENTER.

        

   • Adding a new static route
     1. In the Select Action – Routes window, click New route and press ENTER.

        The New static route window opens.

        

     2. Specify the settings of the new static route:
        • In the Address field, enter the IP address of the network adapter.
        • In the Netmask field, enter the network mask.
        • In the Gateway field, enter the address of the gateway.
     3. Save the settings by clicking Оk.
     4. If you want to change the network adapter of the selected route, select Route via, then in the Select interface to set route via window, select the network adapter for the static route and press ENTER.

        

   • Deleting a static route
     1. In the Select Action – Routes window, select a route from the list.

        This opens the Select Action – Edit static routewindow.

        

     2. Select Delete static route, then in the Delete static route window, click Yes.

        

3. Configure the static route in the Select Action – Edit static route window, then select Go back.

   This opens the Select Action – Routes window with a modified list of static routes.

4. In the Select Action – Routes window, click Go back.

   This opens the Select Action – Routing window.

5. In the Select Action – Routing window, click Continue.

Page top