Managing access control lists (ACLs)

The table of access control lists is displayed in the CPE template and on the device:

• To display the table of access control lists in a CPE template, go to the SD-WAN → CPE templates menu section, click the template, and in the displayed settings area, select the Routing filters → Access control lists tab.
• To display the table of access control lists on a CPE device, go to the SD-WAN → CPE menu section, click the device, and in the displayed settings area, select the Routing filters → Access control lists tab.

Information about access control lists is displayed in the following columns of the table:

• Name is the name of the access control list.
• Inherited specifies whether the access control list is inherited from the CPE template:
  • Yes
  • No

  This column is displayed only on the CPE device.

• Sequence is the sequence number of the rule in the access control list. The rule with the lowest sequence number is the first to be applied to the IPv4 prefix by the access control list.
• Network is the IPv4 prefix to which the access control list must apply the rule.
• Action is the action that the rule performs on an IPv4 prefix:
  • Permit — allow the IPv4 prefix.
  • Deny — deny the IPv4 prefix.
• Management contains the actions that can be performed on the access control list.