Adding IP ranges to the scanned ranges list of a distribution point

You can add IP ranges to the list of scanned ranges of a distribution point.

To add an IP range to the list of scanned ranges:

  1. In the console tree, select the Administration Server node.
  2. In the context menu of the node, select Properties.
  3. In the Administration Server properties window that opens, select the Distribution points section.
  4. In the list, select the necessary distribution point, and then click Properties.
  5. In the distribution point properties window that opens, in the left Sections pane, select Device discovery → IP ranges.
  6. Select the Enable range polling check box.
  7. Click the Add button.

    The Add button is active only if you select the Enable range polling check box.

    The IP range window opens.

  8. In the IP range window, enter the name of the new IP range (the default name is New range).
  9. Click the Add button.
  10. Do one of the following:
    • Specify the IP range using the start and end IP addresses.
    • Specify the IP range using the address and subnet mask.
    • Click Browse and add a subnet from the global list of subnets.
  11. Click OK.
  12. Click OK to add the new range with the specified name.

The new range will appear in the list of scanned ranges.

Page top