Step 2. Transport

This is a required step of the Installation Wizard. On the Transport tab of the Installation Wizard, select or create a connector resource with the settings indicating from where the collector service should receive events.

To add an existing connector to a resource set:

Select the name of the required connector from the Connector drop-down list.

The Transport tab of the Installation Wizard will display the settings of the selected connector. You can open the selected resource for editing in a new browser tab using the button.

To create a new connector:

1. Select Create from the Connector drop-down list.
2. In the Type drop-down list, select the connector type and define its settings on the Basic settings and Advanced settings tabs. The available settings depend on the selected type of connector:
   • internal
   • tcp
   • udp
   • netflow
   • nats
   • kafka
   • http
   • sql
   • file
   • ftp
   • nfs
   • wmi
   • wec
   • snmp

   When using the tcp or upd connector type at the normalization stage, IP addresses of the assets from which the events were received will be written in the DeviceAddress event field if it is empty.

   When using a wmi or wec connector, agents will be automatically created for receiving Windows events.

   It is recommended to use the default encoding (UTF-8), and to apply other settings only if bit characters are received in the fields of events.

The connector resource has been added to the resource set of the collector. The created resource is only available in this resource set and is not displayed in the web interface Resources → Connectors section.

Proceed to the next step of the Installation Wizard.

Page top