Editing SVM network settings

This step is displayed if you are reconfiguring an SVM in a virtual infrastructure running on the Microsoft Hyper-V, Citrix Hypervisor, VMware vSphere, KVM, Proxmox VE, Skala-R, HUAWEI FusionSphere, Nutanix Acropolis, ALT Virtualization Server or Astra Linux platform.

At this step, you can change the virtual network(s) that the SVMs use to connect to Light Agents, the Integration Server and the Kaspersky Security Center Administration Server.

Changing the list of networks on SVMs results in the creation of new network adapters. This could change the IP address of an SVM.

To change the list of virtual networks used by an SVM:

1. Select the Edit SVM network settings check box.

   The window displays a table containing the following information about SVMs selected for reconfiguration:

   • Hypervisor

     IP address in IPv4 format or the fully qualified domain name (FQDN) of the hypervisor on which the SVM is deployed.

   • SVM name

     The name that was defined when specifying SVM settings.

2. For each SVM, specify one or more virtual networks in the Network name column.

   The name of the virtual network that the SVM will use to connect to Light Agents, the Integration Server and the Kaspersky Security Center Administration Server.

   You can specify one or more virtual networks available on the hypervisor. To add or remove a field for selecting virtual networks, use the buttons next to the network selection field.

   If you intend to use dynamic IP addressing (DHCP) for all SVMs, the network settings will be received from the DHCP server via the first virtual network in the list of networks specified for each SVM. Make sure that the Wizard can connect to the SVM with the network settings of the first virtual network received from the DHCP server.

   If the virtual infrastructure uses the VMware Distributed Virtual Switch component, you can specify a Distributed Virtual Port Group to which the SVM will be connected.

3. If the SVMs that you selected for reconfiguration are deployed in a virtual infrastructure running the Microsoft Hyper-V platform, you can also specify the VLAN ID.

   The ID of the virtual local area network (VLAN) that the SVM will use to connect to Light Agents, the Integration Server and the Kaspersky Security Center Administration Server.

   If VLAN is not used, the column shows No.

Proceed to the next step of the wizard.